Crankshaft Position Sensor: Service and Repair

REMOVAL

1. REMOVE GENERATOR ASSEMBLY
2. REMOVE COMPRESSOR AND MAGNETIC CLUTCH
3. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the crankshaft position sensor connector.




b. Remove the bolt, and then remove the crankshaft position sensor.

INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR
a. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.




b. Install the crankshaft position sensor with the bolt.

Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)

c. Connect the crankshaft position sensor connector.

2. INSTALL COMPRESSOR AND MAGNETIC CLUTCH
3. INSTALL GENERATOR ASSEMBLY