Cylinder Head Assembly
Cylinder headCylinder head set bolt
Outside diameter
Standard 10.85 to 11.00 mm (0.4272 to 0.4331 in.)
Minimum 10.70 mm (0.4213 in.)
Cylinder head sub-assembly
Cylinder head lower 0.05 mm (0.0020 in.)
Intake 0.08 mm (0.0031 in.)
Exhaust 0.08 mm (0.0031 in.)
Warpage
Maximum 0.10 mm (0.0039 in.)
CYLINDER HEAD RH
1st 36 N*m (367 kgf*cm, 27 ft.*lbf)
2nd Turn 90°
3rd Turn 90°
CYLINDER HEAD LH
1st 36 N*m (367 kgf*cm, 27 ft.*lbf)
2nd Turn 90°
3rd Turn 90°
Recessed head
14 mm (0.55 in.) head 30 N*m (306 kgf*cm, 22 ft.*lbf)
INTAKE MANIFOLD
Install and tighten the 6 bolts and 4 nuts uniformly in several steps.
Torque 21 N*m (214 kgf*cm, 15 ft.*lbf)
EXHAUST MANIFOLD LH
Install the exhaust manifold sub-assembly LH with the 6 nuts in the order shown in the illustration.
Torque 21 N*m (214 kgf*cm, 15 ft.*lbf)
EXHAUST MANIFOLD RH
Install the exhaust manifold sub-assembly RH with the 6 nuts in the order shown in the illustration.
Torque 21 N*m (214 kgf*cm, 15 ft.*lbf)
CAMSHAFT BEARING CAP
1st 10 N*m (102 kgf*cm, 7 ft.*lbf)
2nd 16 N*m (163 kgf*cm, 12 ft.*lbf)