Front Door: Adjustments
ADJUSTMENT1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. INSPECT FRONT DOOR
a. Check that the clearance is within the standard range.
3. ADJUST FRONT DOOR
a. Using SST, loosen the bolts on the pillar side to adjust the door front and back, up and down.
SST 09812-00010
Torque: 26 N.m (265 kgf.cm, 19 ft.lbf)
b. Loosen the bolts on the door side to adjust the door up and down, and the door front side to side.
Torque: 26 N.m (265 kgf.cm, 19 ft.lbf)
HINT: Perform this procedure after replacing the centering bolt with the supplied bolt.
c. When adjusting the door rear side to side and the front door lock striker plate assembly, use a "torx" socket wrench (T40) to loosen the screws until the striker can move. Lightly tap it with a brass bar for adjustment.
Torque: 23 N.m (235 kgf.cm, 17 ft.lbf)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION