Without Scan Tool

DTC CHECK (WHEN USING SST CHECK WIRE):

DTC check




1. Using SST, connect terminals TC and CG of the DLC3.

SST 09843-18040

2. Turn the ignition switch on.
3. Read DTC from the ABS and brake control warning lights on the combination meter and multi information display.

HINT:
- If no code appears, inspect the TC and CG terminal circuit, and ABS and brake control warning light circuits.

Trouble Area
TC and CG terminal circuit
ABS warning light circuit
Brake control warning light circuit






- As an example, the illustration shows the blinking patterns of the normal system code and trouble codes 31 and 43, and display of the normal system code and trouble code 31 on the multi information display.

4. Codes are explained in the code table
5. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

END OF DTC CHECK (WHEN USING SST CHECK WIRE):

a. Turn the ignition switch on.
b. Check that the ABS and brake control warning lights go off within approximately 3 seconds.