Torque Specifications

SERVICE SPECIFICATIONS: 1UR-FSE ENGINE MECHANICAL: TORQUE SPECIFICATIONS













Cylinder head x Cylinder block

1st 36 Nm (367 kgf-cm, 27 ft lbf)
2nd Turn 90°
3rd Turn 90°
for 12 mm head 21 Nm (214 kgf-cm, 15 ft lbf)

HEAD BOLT





HINT:
- If a visual check shows no excessively thin areas, check the center of the bolt (see illustration) and find the area that has the lowest diameter.
- If the diameter is less than the minimum, replace the cylinder head bolt.

Camshaft bearing cap

Refer to article in Service and Repair, Reassembly. [1][2]Reassembly

Crankshaft bearing cap x Cylinder block

for Inside position 61 Nm (622 kgf-cm, 45 ft lbf)
for Outside position 27 Nm (275 kgf-cm, 20 ft lbf)
2nd Turn 90°
for Cylinder block side position 45 Nm (459 kgf-cm, 33 ft lbf)

Drive plate and ring gear x crankshaft

1st 30 Nm (306 kgf-cm, 22 ft lbf)
2nd Turn 90°

INTAKE MANIFOLD Specifications

OIL PUMP COVER Specifications

WATER PUMP Specifications