Disassembly

PARKING BRAKE: PARKING BRAKE ASSEMBLY: DISASSEMBLY

DISASSEMBLY

1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH
(a) Remove the 2 bolts and separate the rear disc brake caliper assembly LH.
HINT: Do not disconnect the flexible hose from the brake caliper.

3. REMOVE REAR DISC






(a) Release the parking brake, and remove rear disc.
- Put matchmarks on the disc and remove the axle shaft.
- If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns freely.

4. INSPECT BRAKE DISC INSIDE DIAMETER






(a) Using a brake drum gauge or equivalent, measure the inside diameter of the disc.
Standard inside diameter:
210 mm (8.27 in.)
Maximum inside diameter:
211 mm (8.30 in.)
5. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING






(a) Using a needle-nose pliers, remove the 2 return tension springs.
6. REMOVE PARKING BRAKE SHOE STRUT COMPRESSION SPRING
(a) Slide out the front shoe and remove the compression spring.
7. REMOVE PARKING BRAKE SHOE STRUT LH
8. REMOVE PARKING BRAKE SHOE






(a) Release the cup claw and remove the front and rear parking brake shoe.
(b) Disconnect the parking brake cable from the shoe lever.
(c) Remove the tension spring and shoe adjuster screw set from the front and rear shoes.
(d) Remove the 2 shoe hold-down springs, 4 cups and 2 pins.






(e) Using a screwdriver, remove the C-washer.
(f) Remove the shim and shoe lever from the parking brake shoe.