Fuel Receiver Gauge Malfunction

METER: METER / GAUGE SYSTEM: Fuel Receiver Gauge Malfunction

Fuel Receiver Gauge Malfunction

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT FUEL SENDER GAUGE ASSEMBLY
(a) Remove the fuel sender gauge assembly.





(b) Check that the float position is between E and F.
(c) Measure the resistance between terminals 2 and 3 of the connector according to the value(s) in the table below.
Standard resistance:






NG -- REPLACE FUEL SENDER GAUGE ASSEMBLY
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (FUEL SENDER GAUGE - COMBINATION METER)
(a) Disconnect the C9, C11and F5 connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE COMBINATION METER ASSEMBLY