Reassembly

STEERING COLUMN: STEERING COLUMN ASSEMBLY: REASSEMBLY

REASSEMBLY

1. INSTALL KEY INTER LOCK SOLENOID
(a) Install the key inter lock solenoid to the steering column bracket assembly upper with 2 screws.
2. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY
(a) Install the ignition or starter switch assembly to the steering column bracket assembly upper with 2 screws.
3. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY






(a) Install the un-lock warning switch assembly to the steering column bracket assembly upper.
(b) Connect the un-lock warning switch assembly connector to the ignition or starter switch assembly.
4. INSTALL IGNITION SWITCH LOCK CYLINDER & KEY SET
(a) Make sure that the ignition switch lock cylinder assembly is at the ACC position.
(b) Install the ignition switch lock cylinder assembly.
5. INSTALL TRANSPONDER KEY AMPLIFIER
NOTE: Take care not to push the amplifier up with excessive force to prevent it from being damaged.





(a) Align the transponder key amplifier with the installation position of the upper bracket with the amplifier inclined.
(b) Push up the transponder key amplifier and connect it to the upper bracket.
6. INSPECT STEERING LOCK OPERATION






(a) Check that the steering mechanism is activated when removing the key.
(b) Check that the steering mechanism is deactivated when inserting the key and turning it to ACC position.
7. INSTALL STEERING COLUMN BRACKET ASSEMBLY UPPER






(a) Temporarily install the steering column bracket assembly upper and steering column upper clamp with the 2 new tapered-head bolts.
(b) Tighten the 2 tapered-head bolts until the bolt heads break off.
8. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY
(a) Align the matchmarks on the steering column assembly and the steering intermediate shaft assembly.
(b) Install the steering intermediate shaft assembly and thrust stopper to the steering column assembly with the bolt.
Torque: 36 Nm (370 kgf-cm, 26 ft-lbf)