Installation

SUSPENSION: FRONT UPPER SUSPENSION ARM:

INSTALLATION

1. INSTALL FRONT SUSPENSION UPPER ARM BUSH LH






(a) Using SST and a press, install a new front suspension upper arm bush LH (front side).
SST: 09710-26010
09710-05061
(b) Install the rear side by the same procedures with the front side.
2. TEMPORARILY TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH






(a) Install the front suspension upper arm assembly, and temporarily tighten bolt, the 2 washers and the nut.






(b) Install the bracket with the bolt.
Torque: 5.8 Nm (59 kgf-cm, 51 in-lbf)






(c) Install a new nut and a new clip.
Torque: 110 Nm (1,120 kgf-cm, 81 ft-lbf)
3. CONNECT SKID CONTROL SENSOR WIRE






(a) Install the connect skid control sensor wire with the 2 bolts.
Torque: 13 Nm (130 kgf-cm, 9 ft-lbf)
4. INSTALL FRONT DISC WHEEL
Torque: 112 Nm (1,140 kgf-cm, 83 ft-lbf)
5. STABILIZE SUSPENSION
HINT: Service Precautions

6. FULLY TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH






(a) Fully tighten the nut.
Torque: 115 Nm (1,170 kgf-cm, 85 ft-lbf)
7. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT: Service and Repair