Kinetic Dynamic Suspension System

SUSPENSION CONTROL: KINETIC DYNAMIC SUSPENSION SYSTEM: DTC CHECK / CLEAR

DTC CHECK / CLEAR

1. CHECK DTC (USING SST CHECK WIRE)
(a) Checking DTCs using the SST check wire.





SST: 09843-18040
(1) Using the SST, connect terminals TC and CG of the DLC3.
(2) Turn the ignition switch to the ON position.





(3) Read and record any DTCs from the KDSS indicator light on the combination meter.





(4) As examples, the blinking patterns of a normal system code and codes 13 and 33 are shown in the illustration.
- If the KDSS indicator light does not blink any DTC or a normal system code, inspect the KDSS indicator light circuit Indicator Circuit or the TC terminal circuit TC and CG Terminal Circuit.
- If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.
(5) Refer to the Diagnostic Trouble Code Chart Kinetic Dynamic Suspension System for DTC information.
(6) After completing the check, remove the SST check wire from the DLC3.
SST: 09843-18040
(b) Clearing the DTCs using the SST check wire.





(1) Make sure that the ignition switch is off.
(2) Using SST, connect terminals TC and CG of the DLC3.
SST: 09843-18040
(3) Turn the ignition switch to the ON position.





(4) Clear DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
(5) Check that the KDSS indicator light shows a normal system code.
HINT: If the fault has not been repaired, the DTC code may still be displayed.
(6) Turn the ignition switch off.
(7) Remove the SST check wire from the DLC3.
SST: 09843-18040
HINT: Disconnecting the battery cable during the operation will not erase DTCs in the ECU.

2. CHECK DTC (USING TECHSTREAM)
(a) Checking DTCs using the Techstream.
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to the ON position.
(3) Read DTCs by following the prompts on the Techstream screen.
HINT: Refer to the Techstream operator's manual for further details.

(b) Clearing the DTCs using the Techstream.
HINT: After repairing the malfunctions, clear the DTCs.
(1) Connect the Techstream to the DLC3
(2) Turn the ignition switch to the ON position.
(3) Erase the DTCs following the prompts on the Techstream screen.
HINT: Refer to the Techstream operator's manual for further details.