Operation CHARM: Car repair manuals for everyone.

P0A94-550








L110F HYBRID VEHICLE CONTROL: HYBRID CONTROL SYSTEM: P0A94-550: DC / DC Converter Performance

DTC P0A94-550 - DC / DC Converter Performance

DESCRIPTION

For a description of the boost converter, P0A94-442.






MONITOR DESCRIPTION

If the boost converter (inverter with converter assembly) detects a circuit malfunction, it transmits a boost converter overvoltage signal to the MG ECU. The MG ECU will send information about the malfunction to the hybrid vehicle control ECU. Upon receiving this information, the hybrid vehicle control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS





TYPICAL MALFUNCTION THRESHOLDS





COMPONENT OPERATING RANGE





INSPECTION PROCEDURE

PROCEDURE

1. CHECK CONNECTOR CONNECTION CONDITION (INVERTER WITH CONVERTER ASSEMBLY CONNECTOR)
NOTE: Before disconnecting the connector, confirm that it is properly connected by checking that the locking claws are engaged and that the connector does not pull out.





(a) Check the connection of the low voltage connector of the inverter with converter assembly.
Result:
The connectors are connected securely and there are no contact problems.
HINT: When connecting the connector, insert it with the locking lever in the raised position. Rotate the lever downward and make sure that the connector is pulled into its socket. When the locking lever is in its fully closed position, a click will be heard as its locking claws engage. After the click is heard, pull up on the connector to confirm that it is properly connected.

NG -- CONNECT SECURELY
OK -- REPLACE INVERTER WITH CONVERTER ASSEMBLY