Cruise Main Indicator Light Circuit

CRUISE CONTROL: DYNAMIC LASER CRUISE CONTROL SYSTEM: Cruise Main Indicator Light Circuit

Cruise Main Indicator Light Circuit

DESCRIPTION

When the cruise control main switch is on, the CRUISE main indicator light and READY indicator come on. This indicates the control condition (presence or absence of a vehicle in front, vehicle-to-vehicle distance, and set vehicle speed) and fail-safe state through the multiplex communication system. The master warning light and CRUISE main indicator light come on and vehicle-to-vehicle distance information is displayed on the combination meter as the alarm buzzer sounds.
HINT: If the vehicle in front in the same lane significantly decreases vehicle speed or another vehicle cuts in front of your vehicle, adequate deceleration cannot be applied and the vehicle-to-vehicle distance will shorten. At this time, the system sounds the buzzer and the multi-information display blinks to warn the driver.

INSPECTION PROCEDURE
HINT: When not using an intelligent tester, go to the combination meter system How To Proceed With Troubleshooting.

PROCEDURE

1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
(a) Connect the intelligent tester to the DLC3.
(b) Select the ACTIVE TEST, use the intelligent tester to generate a control command, and then check that the CRUISE main indicator light comes on.

Combination meter (Meter ECU):





OK:
Indicator light comes on.
NG -- REPLACE COMBINATION METER ASSEMBLY
OK -- Continue to next step.
2. READ VALUE ON INTELLIGENT TESTER
(a) Connect the intelligent tester to the DLC3.
(b) Turn the ignition switch on, and turn the intelligent tester main switch on.
(c) Check the DATA LIST for proper functioning of the CRUISE main indicator light.

ECM (Cruise control):





OK:
When the cruise control main switch is operated, the display changes as shown above.
HINT: 1 is OK, but 2 is NG -> DTC output or ECM failure

NG -- REPLACE ECM
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE