Dynamic Laser Cruise Control System

CRUISE CONTROL: DYNAMIC LASER CRUISE CONTROL SYSTEM: DTC CHECK / CLEAR

DTC CHECK / CLEAR





1. CHECK DTC
(a) Connect the intelligent tester to the DLC3.
(1) Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the Data Link Connector 3 (DLC3).
(b) Turn the ignition switch on.
(c) Read the DTCs by following the prompts on the tester screen.
HINT: Refer to the intelligent tester operator's manual for further details.

2. CLEAR DTC
(a) Connect the intelligent tester to the DLC3.
(b) Turn the ignition switch on.
(c) Operate the intelligent tester to erase the codes.
HINT: Refer to the intelligent tester operator's manual for further details.