Installation

AIR CONDITIONING: CONDENSER: INSTALLATION

INSTALLATION

1. INSTALL COOLER CONDENSER ASSEMBLY






(a) Install the cooler condenser assembly with the 2 screws.
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)
HINT: If the condenser is replaced with a new one, add compressor oil to the new condenser.

Capacity:
40 cc (1.4 fl. oz.)
Compressor oil:
ND-OIL 8 or equivalent






(b) Install the 2 radiator support brackets.
2. INSTALL NO. 1 RADIATOR SUPPORT

3. INSTALL RADIATOR SUPPORT CUSHION

4. INSTALL RADIATOR SUPPORT SUB-ASSEMBLY UPPER

5. INSTALL HOOD LOCK ASSEMBLY

6. INSTALL HOOD LOCK CONTROL CABLE COVER

7. INSTALL NO. 1 AIR CLEANER INLET

8. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

9. INSTALL NO. 2 AIR CLEANER INLET

10. INSTALL COOL AIR INTAKE DUCT SEAL

11. INSTALL COOLER REFRIGERANT DISCHARGE PIPE
(a) Remove the attached vinyl tape from the pipe and connecting part of the cooler condenser assembly.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring to the cooler refrigerant discharge pipe.






(d) Connect the cooler refrigerant discharge pipe to the cooler condenser assembly with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 47 in-lbf)
12. INSTALL LIQUID TUBE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the tube and connecting part of the cooler condenser assembly.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring on the liquid tube sub-assembly.






(d) Connect the liquid tube sub-assembly to the cooler condenser assembly with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 47 in-lbf)
13. CHARGE WITH REFRIGERANT
SST: 07110-58060
07117-58060
07117-58070
07117-58080
07117-58090
07117-78050
07117-88060
07117-88070
07117-88080
Specified amount:
550 to 650 g (19.4 to 22.9 oz.)
14. WARM UP ENGINE
15. CHECK FOR REFRIGERANT LEAK