Steering Angle Sensor Communication Stop Mode

CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: Steering Angle Sensor Communication Stop Mode

Steering Angle Sensor Communication Stop Mode

DESCRIPTION

HINT: "STEERING SENSOR" refers to the circuit that includes the steering angle sensor.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK OPEN IN CAN BUS WIRE (STEERING ANGLE SENSOR BRANCH WIRE)
(a) Turn the ignition switch to the LOCK position.
(b) Disconnect the steering angle sensor connector (S10).

NG -- REPAIR OR REPLACE STEERING ANGLE SENSOR BRANCH WIRE OR CONNECTOR (CAN-H, CAN-L)
OK -- Continue to next step.
2. CHECK WIRE HARNESS (IG, ESS)

(a) Measure the resistance according to the value in the table below.
Standard resistance:

(b) Measure the voltage according to the value in the table below.
Standard voltage:

NOTE: Perform the measurement from the back of the connector with the connector connected.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE STEERING ANGLE SENSOR