Installation

SEAT BELT: REAR CENTER SEAT OUTER BELT ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY






(a) Check the degree of tilt when the ELR begins to lock.
(1) Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt when gently moving the installed retractor.
NOTE: Do not disassemble the retractor.





(b) Install the rear center seat outer belt assembly with the bolt and nut.
Bolt - Torque: 7.5 Nm (77 kgf-cm, 66 in-lbf)
Nut - Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
2. INSTALL SEPARATE TYPE REAR SEATBACK COVER WITH PAD Reassembly

3. INSTALL REAR SEAT LOCK STRIKER Reassembly

4. INSTALL REAR SEATBACK LOCK STRIKER PROTECTOR
5. INSTALL REAR SEATBACK LOCK BEZEL UPPER
6. INSTALL REAR SEAT HEADREST SUPPORT
7. INSTALL REAR SEAT HEADREST SUPPORT
8. INSTALL REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY
9. INSTALL REAR SEATBACK LOCK STRIKER COVER
10. INSTALL REAR SEAT HEADREST ASSEMBLY
11. INSTALL REAR SEAT INNER BELT ASSEMBLY Removal

12. INSTALL SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY Reassembly

13. INSTALL REAR SEAT CUSHION MOULDING REAR RH
14. INSTALL REAR SEAT CUSHION MOULDING RH
15. INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY
16. INSTALL REAR SEATBACK COVER
17. INSTALL CENTER SEAT ASSEMBLY
18. INSTALL CENTER SEAT HINGE COVER UPPER LH
19. INSTALL RECLINING COVER PROTECTOR LH
20. INSTALL REAR SEAT ASSEMBLY RH Installation

21. INSTALL REAR SEAT TRACK BRACKET COVER
22. INSPECT SLIDE ADJUSTER LOCK Installation