Removal

2GR-FE CHARGING: GENERATOR: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT WHEEL RH
3. REMOVE NO. 1 ENGINE UNDER COVER
4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
5. REMOVE FRONT FENDER APRON SEAL RH
6. REMOVE ENGINE ROOM COVER SIDE

7. REMOVE V-BANK COVER SUB-ASSEMBLY

8. REMOVE COOL AIR INTAKE DUCT SEAL

9. REMOVE NO. 2 AIR CLEANER INLET

10. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

11. REMOVE NO. 1 AIR CLEANER INLET

12. DISCONNECT RADIATOR RESERVOIR TANK HOSE

13. REMOVE HOOD LOCK CONTROL CABLE COVER

14. REMOVE HOOD LOCK ASSEMBLY

15. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY

16. REMOVE FAN SHROUD

17. REMOVE V-RIBBED BELT

18. REMOVE GENERATOR ASSEMBLY






(a) Remove the terminal cap.
(b) Remove the nut and disconnect the wire harness from terminal B.
(c) Disconnect the generator connector from the generator assembly.
(d) Disconnect the connector from the compressor and magnetic clutch.
(e) Disconnect the 2 wire harness clamps.






(f) Remove the 2 bolts.






(g) Remove the bolt from the cylinder block.
(h) Disconnect the wire harness clamp and remove the generator assembly.






(i) Remove the bolt and wire harness clamp stay.






(j) Remove the bolt and bracket.