Installation

STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column): INSTALLATION

INSTALLATION

1. INSTALL STEERING SHAFT UNIVERSAL JOINT ASSEMBLY






(a) Align the matchmarks on the steering universal joint assembly and steering main shaft assembly.
(b) install the steering universal joint assembly with the bolt.
Torque: 35 Nm (360 kgf-cm, 26 ft-lbf)
2. INSTALL STEERING COLUMN HOLE COVER






(a) Install the steering column hole cover sub-assembly No.2 to the steering intermediate shaft sub-assembly.
3. TEMPORARILY TIGHTEN STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY






(a) Align the matchmarks on the steering intermediate shaft sub-assembly and steering main shaft assembly.
(b) Temporarily install the steering intermediate shaft sub-assembly with the bolt.
4. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU






(a) Using a socket wrench (+), install the 2 screws.
Torque: 1.5 Nm (15 kgf-cm, 13 in-lbf)
(b) Connect the connectors to the multiplex tilt and telescopic ECU.
NOTICE:
- The wire harness between the telescopic motor and ECU has same shape connectors at both ends.
- When installing them, connect the connectors with the same color.

5. INSTALL STEERING COLUMN ASSEMBLY






(a) Install the steering column assembly with the 2 bolts and 2 nuts.
Torque: 26 Nm (265 kgf-cm, 19 ft-lbf)
(b) Connect the connectors.
(c) Connect the wire harness clamps to the steering column tube.
6. CONNECT STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY






(a) Align the matchmarks on the intermediate shaft sub-assembly and steering gear assembly.
(b) Install the bolt.
Torque: 35 Nm (360 kgf-cm, 26 ft-lbf)






(c) Tighten the bolt B.
Torque: 35 Nm (360 kgf-cm, 26 ft-lbf)
(d) Install the steering column hole cover No.2 to the steering hole shield.
(e) Install the clamp to the steering column hole shield and tighten the bolt A.
7. INSTALL AIR DUCT NO.1
(a) Install the air dust No.1 with the bolt.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)
8. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY Installation

9. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
10. INSTALL SPIRAL CABLE SUB-ASSEMBLY Installation

11. INSTALL TILT AND TELESCOPIC SWITCH






(a) Engage the claw to install the tilt and telescopic switch.
(b) Connect the connector.
12. INSTALL STEERING COLUMN COVER






(a) Install the steering column cover UPR and LWR with the 3 screws.
13. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
14. CENTER SPIRAL CABLE Installation

15. INSTALL STEERING WHEEL ASSEMBLY
(a) Align the matchmarks on the steering wheel assembly and steering main shaft assembly.
(b) Install the steering wheel assembly set nut.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
16. INSPECT STEERING WHEEL CENTER POINT
17. INSTALL HORN BUTTON ASSEMBLY Installation

18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Repair Instruction - Initialization

19. INSPECT HORN BUTTON ASSEMBLY Installation

20. INSPECT SRS WARNING LIGHT
Diagnosis System