Reassembly

STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column): REASSEMBLY

REASSEMBLY

1. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY
(a) Install the ignition or starter switch assembly to the steering column bracket assembly UPR with the 2 screws.
2. INSTALL KEY INTER LOCK SOLENOID
(a) Install the solenoid to the steering column bracket assembly with the 2 screws.
3. INSTALL UN-LOCK WARNING SWITCH ASSEMBLY






(a) Install the un-lock warning switch assembly.
(b) Connect the terminals 3 and 4 of the un-lock warning switch assembly connector.
(c) Connect the un-lock warning switch assembly connector to the ignition or starter switch assembly.
4. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY
(a) Make sure the ignition switch lock cylinder assembly is in the ACC position.
(b) Install the ignition switch lock cylinder assembly.
5. INSPECT STEERING LOCK OPERATION
(a) Check that the steering lock mechanism is activated when the key is removed.
(b) Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.
6. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY






(a) Temporarily install the steering column upper w/ switch bracket assembly and steering column upper clamp with 2 new tapered-head bolts.
(b) Tighten the 2 tapered-head bolts until the bolt heads break off.
7. INSTALL TRANSPONDER KEY AMPLIFIER






(a) Align the transponder key amplifier with the installation position of the upper bracket with the amplifier inclined.
(b) Push the transponder key amplifier up and connect it to the upper bracket.
NOTE: Do not push the amplifier up with excessive force.