Installation

U151F AUTOMATIC TRANSAXLE: DIFFERENTIAL OIL SEAL: INSTALLATION

INSTALLATION

1. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL






(a) Coat the lip of the oil seal with MP grease.
(b) Using SST and a hammer, install a new oil seal.
SST: 09223-15020
SST: 09950-70010
09951-07200
Oil seal installation depth:
-0.5 to 0.5 mm (-0.020 to 0.020 in.)
2. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH Installation

3. INSTALL FRONT AXLE ASSEMBLY LH Installation

4. INSTALL NO. 1 FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER LH Installation

5. INSTALL TIE ROD END SUB-ASSEMBLY LH Installation

6. INSTALL SPEED SENSOR FRONT LH Installation

7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH Installation

8. INSTALL FRONT AXLE SHAFT LH NUT Installation

9. INSTALL FRONT WHEELS
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
10. ADD AUTOMATIC TRANSAXLE FLUID
11. INSPECT AUTOMATIC TRANSAXLE FLUID Procedures

12. INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 engine under cover)
13. INSTALL NO. 1 ENGINE UNDER COVER
14. INSTALL ENGINE UNDER COVER ASSEMBLY (w/ engine under cover assembly)
15. CHECK ABS SPEED SENSOR SIGNAL Installation

16. PERFORM INITIALIZATION
HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.

17. INSTALL TRANSAXLE HOUSING OIL SEAL






(a) Coat the lip of the oil seal with MP grease.
(b) Using SST and a hammer, install a new oil seal.
SST: 09649-17010
SST: 09950-70010
09951-07200
Oil seal installation depth:
5.5 to 6.5 mm (0.217 to 0.256 in.)
18. INSTALL TRANSFER ASSEMBLY Installation

19. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER Installation

20. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH Installation

21. INSTALL TRANSFER STIFFENER PLATE RH Installation

22. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
Installation

23. INSTALL TRANSFER DRAIN PLUG Installation

24. INSTALL TRANSFER CASE NO. 2 PLUG Installation

25. INSTALL TRANSFER CASE NO. 1 PLUG Installation