Removal

U151F AUTOMATIC TRANSAXLE: DIFFERENTIAL OIL SEAL: REMOVAL

REMOVAL

1. REMOVE FRONT WHEELS
2. REMOVE ENGINE UNDER COVER ASSEMBLY (w/ engine under cover assembly)
3. REMOVE NO. 1 ENGINE UNDER COVER
4. REMOVE NO. 2 ENGINE UNDER COVER (w/ No. 2 engine under cover)
5. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug and gasket, and drain ATF.
(b) Install a new gasket and the drain plug.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
6. REMOVE FRONT AXLE HUB NUT LH Removal

7. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH Removal

8. SEPARATE SPEED SENSOR FRONT LH Removal

9. SEPARATE TIE ROD END SUB-ASSEMBLY LH Removal

10. SEPARATE NO. 1 FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER LH Removal

11. REMOVE FRONT AXLE ASSEMBLY LH Removal

12. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal

13. REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL






(a) Using SST, pull out the oil seal.
SST: 09308-00010
14. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
Removal

15. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH Removal

16. REMOVE TRANSFER STIFFENER PLATE RH
17. REMOVE AUTOMATIC TRANSMISSION WITH TRANSFER Removal

18. REMOVE TRANSFER CASE NO. 1 PLUG Removal

19. REMOVE TRANSFER CASE NO. 2 PLUG Removal

20. REMOVE TRANSFER DRAIN PLUG Removal

21. REMOVE TRANSFER ASSEMBLY Removal

22. REMOVE TRANSAXLE HOUSING OIL SEAL






(a) Using a screwdriver with vinyl tape wrapped around its tip, remove the oil seal.
NOTE: Be careful not to damage the housing.