Installation

DIFFERENTIAL: REAR DIFFERENTIAL CARRIER ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL NO. 1 REAR DIFFERENTIAL SUPPORT






(a) Install the rear differential support No. 1 to the differential carrier assembly rear with the 2 bolts and 2 lock nuts.
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
2. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY






(a) Jack up the differential carrier assembly rear and rear suspension member with a jack.
(b) Connect the rear differential support No. 1 to the rear suspension member with 2 bolts and 2 lock nuts.
Torque: 137 Nm (1,400 kgf-cm, 101 ft-lbf)






(c) Install the differential carrier assembly rear to the rear suspension member sub-assembly with the 3 bolts.
Torque: 95 Nm (970 kgf-cm, 70 ft-lbf)
3. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

4. INSTALL REAR DRIVE SHAFT ASSEMBLY LH Installation

5. INSTALL EXHAUST PIPE ASSEMBLY Installation

6. INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY Installation

7. FULLY TIGHTEN PROPELLER W/CENTER BEARING SHAFT ASSEMBLY Installation

8. INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 engine under cover)
9. INSTALL ENGINE UNDER COVER ASSEMBLY (w/ engine under cover assembly)
10. INSTALL REAR DIFFERENTIAL DRAIN PLUG
(a) Using a hexagon wrench (10 mm), install the filler plug with a new gasket.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
11. ADD DIFFERENTIAL OIL
(a) Fill the rear differential carrier assembly with hypoid gear oil.
12. INSPECT DIFFERENTIAL OIL Adjustments

13. INSTALL REAR DIFFERENTIAL FILLER PLUG
(a) Using a hexagon wrench (10 mm), install the filler plug with a new gasket.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
14. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
15. CHECK FOR EXHAUST GAS LEAK
16. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

17. ADJUST HEADLIGHT AIM ONLY (w/ HID Headlight System)

18. CHECK ABS SPEED SENSOR SIGNAL