Installation

DRIVE SHAFT: REAR DRIVE SHAFT (for TMMC Made 4WD): INSTALLATION

INSTALLATION

1. INSTALL REAR DRIVE SHAFT ASSEMBLY






(a) Align the shaft splines and install the drive shaft assembly using a brass bar and hammer.
- Set the snap ring with the opening side facing downward.
- Be careful not to damage the oil seal boot and dust cover.
- Move the drive shaft assembly while keeping it level.

2. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY Installation

3. TEMPORARILY TIGHTEN NO. 2 REAR SUSPENSION ARM ASSEMBLY

4. TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY

5. TEMPORARILY TIGHTEN NO. 1 REAR SUSPENSION ARM ASSEMBLY

6. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Air Suspension)

7. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ HID Headlight System)

8. INSTALL REAR AXLE SHAFT NUT Installation

9. INSTALL REAR SPEED SENSOR Installation

10. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
11. STABILIZE SUSPENSION

12. FULLY TIGHTEN NO. 2 REAR SUSPENSION ARM ASSEMBLY

13. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY

14. FULLY TIGHTEN NO. 1 REAR SUSPENSION ARM ASSEMBLY

15. ADJUST REAR WHEEL ALIGNMENT

16. CHECK HEADLIGHT AIM ONLY (w/ HID Headlight System)

17. CHECK ABS SPEED SENSOR SIGNAL