Installation

MF2A TRANSFER: BEARING RETAINER OIL SEAL: INSTALLATION

INSTALLATION

1. INSTALL TRANSFER RH BEARING RETAINER OIL SEAL






(a) Using SST(s), install a new transfer RH bearing retainer oil seal to the transfer case at the position as show in the illustration.
SST: 09223-46011
NOTE: Do not install the oil seal obliquely.

(b) Apply small amount of MP grease to the oil seal lip.
2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
Installation

3. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
4. ADD AUTOMATIC TRANSAXLE FLUID
Procedures

5. INSTALL TRANSFER DRAIN PLUG Installation

6. INSTALL TRANSFER CASE NO. 1 PLUG Installation

7. INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 engine under cover)
8. INSTALL NO. 1 ENGINE UNDER COVER
9. INSTALL ENGINE UNDER COVER ASSEMBLY (w/ engine under cover assembly)
10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

11. CHECK ABS SPEED SENSOR SIGNAL