Removal

WINDSHIELD / WINDOWGLASS: REAR QUARTER WINDOW GLASS: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation Service Precautions.

2. REMOVE REAR DOOR SCUFF PLATE LH Removal

3. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
4. REMOVE DECK BOARD SUB-ASSEMBLY Removal

5. REMOVE TONNEAU COVER ASSEMBLY
6. REMOVE DECK FLOOR BOX FRONT Removal

7. REMOVE DECK FLOOR BOX REAR Removal

8. REMOVE NO.2 DECK BOARD SUB-ASSEMBLY Removal

9. REMOVE NO.3 DECK BOARD SUB-ASSEMBLY Removal

10. REMOVE BACK DOOR WEATHERSTRIP
11. REMOVE JACK CARRIER ASSEMBLY
12. REMOVE DECK SIDE TRIM BOX RH
13. REMOVE DECK SIDE TRIM BOX LH Removal

14. REMOVE REAR FLOOR FINISH PLATE Removal

15. REMOVE REAR FLOOR FINISH SIDE PLATE LH Removal

16. REMOVE DECK SIDE TRIM COVER LH Removal

17. SEPARATE REAR NO.1 SEAT BELT ASSEMBLY OUTER LH
18. REMOVE REAR SEAT SIDE COVER LH Removal

19. REMOVE ROPE HOOK Removal

20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH Removal

21. REMOVE NO.2 ROOM LIGHT ASSEMBLY Removal

22. REMOVE ROOF SIDE GARNISH ASSEMBLY INNER LH Removal

23. REMOVE QUARTER WINDOW ASSEMBLY LH






(a) Pass a piano wire between the vehicle body and glass from the interior.






(b) Tie both wire ends to wooden blocks or similar objects.
NOTE: When separating the glass, take care not to damage the paint and the interior and exterior ornaments.
HINT: Apply protective tape to the outer surface to prevent the surface from being scratched.

(c) Cut off the adhesive by pulling the piano wire around the glass.
(d) Using a suction cup, remove the glass.
NOTE: Leave as much adhesive on the vehicle body as possible when removing the glass.

24. CLEAN QUARTER WINDOW ASSEMBLY LH
(a) Clean the outer circumference of the glass with a non-residue solvent.
NOTICE:
- Do not touch the glass surface after cleaning it.
- Be careful not to damage the glass.