Replacement

AXLE: REAR AXLE HUB BOLT: REPLACEMENT

REPLACEMENT
HINT: Replace the RH side using the same procedures as for the LH side.

1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH
(a) Separate rear disc brake caliper assembly LH for 2WD Removal.
3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH
(a) Separate rear disc brake caliper assembly LH for 4WD Removal.
4. REMOVE REAR DISC
5. REMOVE REAR AXLE LH HUB BOLT






(a) Temporarily install the 2 nuts and washers to the rear axle LH hub bolt as shown in the illustration.
(b) Using SST(s) and a hammer handle or an equivalent to hold the hub & bearing assembly, remove the rear axle LH hub bolt.
SST: 09628-10011
6. INSTALL REAR AXLE LH HUB BOLT






(a) Install a washer and nut to a new bolt, as shown in the illustration.
(b) Using a hammer handle or an equivalent to hold the hub & bearing assembly, install the rear axle LH hub bolt by tightening the nut.
7. INSTALL REAR DISC
8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
(a) Install rear disc brake caliper assembly LH for 2WD Installation.
9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
(a) Install rear disc brake caliper assembly LH for 4WD Installation.
10. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)