Installation

SUSPENSION: REAR NO. 2 SUSPENSION ARM (for 2WD): INSTALLATION

INSTALLATION

1. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 LH






(a) Install the rear suspension arm assembly No. 2 (inner side) with the bolt, and temporarily tighten the bolt.
HINT: Ensure that the paint mark faces to the rear.





(b) Connect the rear suspension arm assembly No. 2 (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt.
NOTE: When installing the bolt, tighten the bolt temporarily with the nut fixed.

2. STABILIZE SUSPENSION Installation

3. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.2 LH






(a) Fully tighten the bolt.
Torque: 120 Nm (1,224 kgf-cm, 89 ft-lbf)






(b) Fully tighten the bolt.
Torque: 112 Nm (1,142 kgf-cm, 83 ft-lbf)






(c) Install the height control sensor sub-assembly and nut to the suspension arm assembly No. 2 (w/ height control sensor sub-assembly.)
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
4. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
5. INSPECT REAR WHEEL ALIGNMENT
Rear Wheel Alignment
6. ADJUST VEHICLE HEIGHT
7. ADJUST HEADLIGHT AIM ONLY