Pinout Values and Diagnostic Parameters

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM: TERMINALS OF ECU

TERMINALS OF ECU

1. TELEVISION CAMERA ASSEMBLY





(a) Disconnect the T17 camera connector.
(b) Measure the voltage and resistance of each terminal of the wire harness side connector.

Standard:





If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Reconnect the T17 camera connector.
(d) Measure the voltage and frequency of each terminal of the connector.

Standard:





If the result is not as specified, the camera may have a malfunction.





(e) Reference:
Oscilloscope waveform
(1) Waveform 1






2. CHECK TELEVISION CAMERA ECU





(a) Disconnect the T24 ECU connector.
(b) Measure the voltage and resistance between each terminal of the wire harness side connector.





If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Reconnect the T24 ECU connector.
(d) Measure the voltage and waveform between each terminal of the connector.










(e) Using an oscilloscope, check the waveform.