Installation

SLIDING ROOF: SLIDING ROOF HOUSING: INSTALLATION

INSTALLATION

1. INSTALL SLIDING ROOF GLASS SUB-ASSEMBLY





(a) Check for a difference in levels between the sliding roof (weatherstrip) and roof panel.
Dimension (Corner of rear side):
0 +- 1.5 mm (0 +- 0.059 in.)





(b) Check for a difference in levels between the sliding roof (roof glass) and roof panel.
Dimension:
21.4 mm (0.843 in.)
NOTE:
The clearance should be all around even.

2. ADJUST SLIDING ROOF GLASS SUB-ASSEMBLY
(a) Adjust the roof panel.
(1) Using a "TORX" wrench T25, loosen a screw to adjust the sliding roof panel position. When the adjustment has been done, tighten the screw there.
3. RESET SLIDING ROOF POSITION
HINT: Programming and Relearning

4. INSPECT FOR WATER LEAK
(a) Adjusting the sliding roof, check that there is no water leak.
If water leaks, readjust the sliding roof.