Removal

BRAKE: FRONT BRAKE: REMOVAL

REMOVAL
HINT: Overhaul procedure of the RH side is the same as that of with LH side.

1. REMOVE FRONT WHEEL
2. DRAIN BRAKE FLUID
NOTE:
Wash off the brake fluid immediately if it comes into contact with a painted surface.

3. REMOVE FRONT DISC BRAKE ANTIRATTLE W/HOLE PIN





(a) Remove the 2 pin hole clips, then remove the 2 anti-rattle w/ hole pins from disc brake cylinder assembly.
(b) Remove the anti-rattle spring from the disc brake pad.
4. REMOVE DISC BRAKE PAD KIT FRONT (PAD ONLY)
(a) Remove the 2 disc brake pads with anti-squeal shim from the disc brake cylinder assembly.
5. REMOVE ANTI SQUEAL SHIM KIT FRONT
(a) Remove the 2 anti-squeal shims from each of the disc brake pads.
6. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH





(a) Using a union nut wrench, disconnect the brake tube from the disc brake cylinder assembly.
HINT: Use a container to each brake fluid as it drains out.





(b) Remove the 2 bolts and remove the disc brake cylinder assembly.