Removal

BRAKE: REAR BRAKE: REMOVAL

REMOVAL
HINT: Overhaul the RH side by using the same procedures as those for the LH side.

1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID
NOTE:
Wash the brake fluid off immediately if it adheres to any painted surfaces.

3. DISCONNECT REAR LH FLEXIBLE HOSE





(a) Remove the union bolt and gasket from the disc brake cylinder, then disconnect the flexible hose from the disc brake cylinder assembly rear.
HINT: Use a container to catch brake fluid as it drains out.

4. REMOVE DISC BRAKE CYLINDER ASSEMBLY REAR LH





(a) Remove the 2 cylinder slide pins from disc brake cylinder assembly rear.
(b) Remove the disc brake cylinder assembly rear from rear disc brake cylinder mounting.
5. REMOVE DISC BRAKE PAD KIT REAR (PAD ONLY)
(a) Remove the 2 brake pads with anti-squeal shims from rear disc brake cylinder mounting.
6. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM
(a) Remove the 2 anti-squeal shims from each disc brake pads.
7. REMOVE REAR DISC BRAKE PAD WEAR INDICATOR PLATE
(a) Remove the pad wear indicator plate from the inner side disc brake pad.
8. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
(a) Remove the 4 pad support plates from the rear disc brake cylinder mounting.
9. REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH





(a) Remove the 2 bolts and rear brake cylinder mounting.
10. REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH
(a) Remove the 2 cylinder slide bushes from the rear disc brake cylinder mounting.
(b) Remove the cylinder hole plug from the rear disc brake cylinder mounting.