Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION:
After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.





(c) Temporarily install the center airbag sensor assembly with the 3 bolts.
- If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Tighten the 3 bolts to the specified torque.
Torque: 17.5 Nm (179 kgf-cm, 13 ft-lbf)
(e) Check that there is no looseness in the installation parts of the center airbag sensor assembly.
(f) Connect the 3 connectors to the center airbag sensor assembly.
(g) Check that the waterproof sheet is properly set.
2. INSTALL CONSOLE BOX LOWER
3. INSTALL CONSOLE UPPER PANEL GARNISH FRONT
4. INSTALL CONSOLE BOX INSERT
5. INSTALL CONSOLE BOX INSERT FRONT NO. 2
6. INSTALL REAR CONSOLE BOX ASSEMBLY
7. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY
8. INSTALL CONSOLE PANEL UPPER ASSEMBLY
9. INSTALL CONSOLE UPPER PANEL GARNISH NO. 2
10. INSTALL CONSOLE UPPER PANEL GARNISH NO. 1
11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
13. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.