Removal

SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR: REMOVAL

REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the RH side.

1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE QUARTER SCUFF PLATE INNER RH





(a) Remove the 2 quarter scuff plate inner covers.
(b) Using a screwdriver, disengage the 4 claws and remove the scuff plate.
HINT: Tape the screwdriver tip before use.

4. REMOVE FRONT DOOR SCUFF PLATE RH
(a) Using a screwdriver, disengage the 6 claws and remove the scuff plate.
HINT: Tape the screwdriver tip before use.

5. REMOVE REAR DOOR SCUFF PLATE RH
(a) Using a screwdriver, disengage the 6 claws and remove the scuff plate.
HINT: Tape the screwdriver tip before use.

6. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
8. REMOVE LAP BELT OUTER ANCHOR COVER
9. REMOVE CENTER PILLAR GARNISH LOWER RH





(a) Remove the front seat belt anchor bolt and front seat belt.
(b) Disengage the 2 clips and 2 claws, and remove the center pillar garnish.
10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH
11. REMOVE SIDE AIRBAG SENSOR RH





(a) Remove the 2 nuts and the side airbag sensor RH.
(b) Disconnect the connector from the side airbag sensor RH.