B1247

MULTIPLEX COMMUNICATION: MULTIPLEX COMMUNICATION SYSTEM: B1247: Tire Pressure Monitor Receiver Communication Stop

DTC B1247 - Tire Pressure Monitor Receiver Communication Stop

DESCRIPTION

This DTC is detected when the communication between the tire pressure monitor ECU and gateway ECU stops for more than 10 seconds.






WIRING DIAGRAM





INSPECTION PROCEDURE
HINT:
When "+B of GND short malfunction of communication bus" DTCs (B1266 and B1267) are detected at the same time as "communication stop" DTC B1209, repair the "+B or GND short malfunction of communication bus" DTCs first.

PROCEDURE

1. INSPECT FUSE (ECU-IG LH)
(a) Remove the ECU-IG LH fuse from the cowl side J/B LH.
(b) Measure the resistance of the fuse.
Standard resistance:
Below 1 Ohms
NG -- REPLACE FUSE
OK -- Continue to next step.
2. CHECK WIRE HARNESS (TIRE PRESSURE MONITOR ECU - BATTERY AND BODY GROUND)




(a) Disconnect the J49 ECU connector.
(b) Measure the voltage and resistance of the wire harness side connector
Standard voltage:






Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. CHECK RESISTANCE COMMUNICATION LINE




(a) Disconnect the J49, J34 and J76 ECU connectors.
(b) Measure the resistance between the specified terminals on the wire harness side connectors.
Standard resistance:






Result:






C -- REPLACE TIRE PRESSURE MONITOR ECU AND REPAIR OR REPLACE HARNESS OR CONNECTOR
B -- REPAIR OR REPLACE HARNESS OR CONNECTOR
A -- REPLACE TIRE PRESSURE MONITOR ECU