Removal

SUSPENSION CONTROL: SUSPENSION CONTROL ECU: REMOVAL

REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE INSTRUMENT SIDE PANEL RH Removal
4. REMOVE NO. 2 INSTRUMENT CLUSTER MOULDING Removal
5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal
6. REMOVE INSTRUMENT PANEL LOWER Removal
7. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Removal
8. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal
9. DISCONNECT CONNECTORS (W/ Clearance Warning ECU)
10. DISCONNECT CONNECTORS (W/ Parking Assist ECU)
11. REMOVE SUSPENSION CONTROL ECU WITH BRACKET





(a) Disconnect the suspension control ECU connectors.
HINT: Do not apply excessive force to the wire harnesses.





(b) Remove the bolt, nut and bracket.
12. REMOVE SUSPENSION CONTROL ECU





(a) Remove the 2 nuts and suspension control ECU from the bracket.
- Avoid any impact to the suspension control ECU.
- Do not drop the ECU. If it is dropped, replace it with a new one.