Body - 'Pebble Beach Edition' Emblem Loose
L-SB-0163-08November 26, 2008
Pebble Beach Edition Emblem Loose
Service Category
Vehicle Exterior
Section
Exterior Panels/Trim
Market
USA
Applicability
Introduction
Some 2009 model year Pebble Beach Edition RX models may experience a condition where the Pebble Beach Emblem falls off or slides down the fender in hot weather. An improved emblem has been developed to correct this condition. Use the repair procedure below to replace the emblem.
Production Change Information
This TSIB applies to vehicles produced BEFORE the Production Change Effective VINs shown.
Warranty Information
APPLICABLE WARRANTY
^ This repair is covered under the Lexus Comprehensive Warranty. This warranty is in effect for 48 months or 50,000 miles, whichever occurs first, from the vehicle's in-service date.
^ Warranty application is limited to correction of a problem based upon a customer's specific complaint.
Parts Information
Required Tools & Material
Repair Procedure
Repair vehicle by using the improved service part emblem and attaching it to the original location on the fender.
1. Clean the old adhesive from the fender with 3M(TM) General Purpose Adhesive Cleaner (P/N 08984) or equivalent.
2. Install the NEW badge by aligning the badge 10 mm in from the front edge of the fender and 5 mm up from the bottom of the character line (please refer to Figure 1 for the correct location).