Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH
(a) Install the curtain shield airbag assembly LH with the 9 bolts in order shown in the illustration.
Torque: 14 Nm (143 kgf-cm, 10ft-lbf)




NOTICE:
Do not twist the curtain shield airbag assembly LH when installing it.

(b) Connect the connector to the curtain shield airbag assembly LH.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" Installation.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.