Removal

SUPPLEMENTAL RESTRAINT SYSTEM: STEERING PAD: REMOVAL

REMOVAL

1. PRECAUTION
CAUTION:
Be sure to read the "PRECAUTION" thoroughly before servicing Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE STEERING WHEEL NO.3 COVER LOWER





(a) Using a screwdriver, remove the steering wheel No.3 cover lower.
HINT: Tape up the screwdriver tip before use.

4. REMOVE STEERING WHEEL NO.2 COVER LOWER





(a) Using a screwdriver, remove the steering wheel No.2 cover lower.
HINT: Tape up the screwdriver tip before use.

5. REMOVE STEERING PAD





(a) Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.





(b) Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
NOTICE:
When removing the steering pad, do not pull the airbag wire harness.

(c) Disconnect the horn connector.
(d) Disconnect the 2 connectors from the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(e) Remove the steering pad.