Installation

U151F AUTOMATIC TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY





(a) Install the park/neutral position switch to the manual valve shaft.
(b) Temporarily install the 2 bolts.





(c) Place a new lock plate and tighten the nut.
Torque: 6.9 Nm (70 kgf-cm, 61in-lbf)
(d) Temporarily install the control shaft lever.





(e) Turn the lever counterclockwise until it stops and then turn it clockwise 2 notches.
(f) Remove the control shaft lever.





(g) Align the groove with the neutral basic line.
(h) Hold the switch in position and tighten the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48in-lbf)





(i) Using a screwdriver, bend the tabs of the lock plate.





(j) Install the control shaft lever, washer and the nut.
Torque: 13 Nm (130 kgf-cm, 9ft-lbf)





(k) Connect the park/neutral position switch connector.
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Connect the control cable to the control shaft lever with the nut.
Torque: 15 Nm (153 kgf-cm, 11ft-lbf)





(b) Install the control cable to the bracket with a new clip.
3. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY U151F Automatic Transaxle
4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION U151F Automatic Transaxle
5. INSPECT SHIFT LEVER POSITION U151F Automatic Transaxle
6. ADJUST SHIFT LEVER POSITION U151F Automatic Transaxle
7. INSTALL AIR CLEANER BRACKET Installation
8. INSTALL INTAKE AIR RESONATOR SUB-ASSEMBLY Installation
9. INSTALL NO. 1 AIR CLEANER INLET Installation
10. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation
11. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation
12. INSTALL NO. 2 AIR CLEANER INLET Installation
13. INSTALL BATTERY Installation
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.