Installation

SUSPENSION CONTROL: HEIGHT CONTROL VALVE: INSTALLATION

INSTALLATION

1. INSTALL HEIGHT CONTROL VALVE SUB-ASSY NO.1





(a) Install the height control valve sub-assembly No.1 with the 2 nuts.
Torque: 5.4 Nm (55 kgf-cm, 48in-lbf)
(b) Coat 2 new O-rings with MP grease No.2 and install them on each height control tube.





(c) Connect the 3 height control tubes onto the height control valve sub-assembly No.1.
HINT: For the removal procedure of the (type 3) tube, refer to PRECAUTION OF SUSPENSION CONTROL SYSTEM Suspension Control System.

(d) Connect the connector.
2. INSPECT AIR LEAK
3. INSTALL FRONT BUMPER COVER
4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSY LH
5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSY RH
6. INSTALL ENGINE UNDER COVER NO.1
7. INSTALL HEIGHT CONTROL VALVE SUB-ASSEMBLY NO.2





(a) Install the height control valve sub-assembly No.2 with the 2 nuts.
Torque: 5.4 Nm (55 kgf-cm, 48in-lbf)





(b) Coat the O-ring with MP grease.
(c) Install the O-ring onto the height control tube.
(d) Connect the height control tube.
HINT: For the removal procedure of the (type 3) tube, refer to PRECAUTION OF SUSPENSION SYSTEM. Suspension Control System

(e) Install 6 new O-ring and 3 new plates to each installed part of the height control valve No.2 tube.
HINT: When the height control valve No.2 is replaced with a new one, it does not require a new O-ring.





(f) Install the 3 height control tubes.
HINT: For the removal procedure of the (type 2) tube, refer to PRECAUTION OF SUSPENSION CONTROL SYSTEM Suspension Control System

(g) Connect the connector.
8. INSPECT AIR LEAK