Installation

U151E AUTOMATIC TRANSAXLE: TRANSMISSION CONTROL CABLE ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Connect the socket of the transmission control cable assembly to the shift lever assembly.
(b) Connect the control cable end to the shift lever assembly.
(c) Push the stopper cap to the socket as shown in the illustration.
(d) Turn the socket of the transmission control cable assembly clockwise and install the stopper cap.
NOTICE:
- To prevent torsion of the inner cable, the end with protrusion should face up.
- Push the cable end to the bottom of the pin.
- Confirm that the connection between the socket and the shift lock control unit is fixed.





(e) Install the transmission control cable assembly with the 3 bolts.
Torque: 4.9 Nm (50 kgf-cm, 43in-lbf)





(f) Install the transmission control cable bracket No. 2 with the bolt.
Torque: 12 Nm (122 kgf-cm, 9ft-lbf)





(g) Temporarily install the transmission control cable assembly to the control shaft lever with the nut.





(h) Connect the transmission control cable assembly with a new clip to the bracket.
2. INSTALL CENTER AIRBAG SENSOR ASSEMBLY Installation
3. INSTALL AIR DUCT REAR NO. 1
4. INSTALL AIR DUCT REAR NO. 2
5. INSTALL CONSOLE BOX DUCT NO. 1
6. INSTALL CONSOLE COVER LOWER Installation
7. INSTALL REAR CONSOLE BOX Installation
8. INSTALL CONSOLE BOX HOLE COVER NO. 2 Installation
9. INSTALL CONSOLE BOX HOLE COVER Installation
10. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER Installation
11. INSTALL FLOOR CARPET COVER CENTER RH Installation
12. INSTALL FLOOR CARPET COVER CENTER LH Installation
13. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation
14. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 2 Installation
15. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
16. INSTALL FRONT DOOR SCUFF PLATE LH Installation
17. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER Installation
18. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
19. INSTALL FRONT DOOR SCUFF PLATE RH Installation
20. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER Installation
21. INSTALL CONSOLE PANEL UPPER FRONT Installation
22. INSTALL SHIFT LEVER KNOB
23. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
24. INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 engine under cover)
25. INSTALL NO. 1 ENGINE UNDER COVER
26. INSTALL ENGINE UNDER COVER ASSEMBLY (w/ engine under cover assembly)
27. INSPECT SHIFT LEVER POSITION U151F Automatic Transaxle
28. ADJUST SHIFT LEVER POSITION U151F Automatic Transaxle
29. INSPECT SRS WARNING LIGHT
HINT:
Diagnosis System

30. PERFORM INITIALIZATION
HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization