Operation CHARM: Car repair manuals for everyone.
Home >> Lexus >> 2009 >> RX 350 AWD V6-3.5L (2GR-FE) >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Shifter A/T >> Service and Repair >> Removal and Replacement >> U151F Automatic Transaxle >> Installation

Installation








U151F AUTOMATIC TRANSAXLE: SHIFT LEVER: INSTALLATION

INSTALLATION

1. INSTALL SHIFT LEVER ASSEMBLY





(a) Install the shift lever assembly with the 4 nuts.
Torque: 12 Nm (122 kgf-cm, 10ft-lbf)
HINT: Tighten them in the order, A, B, C and D.
NOTICE:
Be careful not to put the wirings of the indicator light or the shift lock system between the floor shift assembly and the floor while installing the floor shift assembly.





(b) Install the pattern select switch connector, the shift lock control computer connector, and the indicator light wire connector.
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Connect the socket of the transmission control cable assembly to the shift lever assembly.
(b) Connect the control cable end to the shift lever assembly.
(c) Push the stopper cap to the socket as shown in the illustration.
(d) Turn the socket of the transmission control cable assembly clockwise and install the stopper cap.
NOTICE:
- To prevent torsion of the inner cable, the end with protrusion should face up.
- Push the cable end to the bottom of the pin.
- Confirm that the connection between the socket and the shift rock control unit is fixed.

3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
(a) Install the shift lever knob sub-assembly.
4. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER Installation
5. INSTALL FLOOR CARPET COVER CENTER RH Installation
6. INSTALL FLOOR CARPET COVER CENTER LH Installation
7. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation
8. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 2 Installation
9. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER Installation
10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
11. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
12. INSTALL FRONT DOOR SCUFF PLATE RH Installation
13. INSTALL FRONT DOOR SCUFF PLATE LH
14. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER Installation
15. INSTALL CONSOLE PANEL UPPER FRONT Installation
16. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
17. INSPECT SHIFT LEVER POSITION U151F Automatic Transaxle
18. ADJUST SHIFT LEVER POSITION U151F Automatic Transaxle
19. PERFORM INITIALIZATION
HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.
pro multis · About Operation CHARM