Installation

MF2AV TRANSFER: BEARING RETAINER OIL SEAL: INSTALLATION

INSTALLATION

1. INSTALL TRANSFER RH BEARING RETAINER OIL SEAL





(a) Using SST(s), install a new transfer RH bearing retainer oil seal to the transfer case at the position as show in the illustration.
SST: 09223-46011
NOTICE:
Do not install the oil seal obliquely.

(b) Apply small amount of MP grease to the oil seal lip.
2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
HINT:
Installation

3. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)
4. ADD AUTOMATIC TRANSAXLE FLUID
HINT:
U151F Automatic Transaxle

5. INSTALL TRANSFER DRAIN PLUG Installation
6. INSTALL TRANSFER CASE NO. 1 PLUG Installation
7. INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 engine under cover)
8. INSTALL NO. 1 ENGINE UNDER COVER
9. INSTALL ENGINE UNDER COVER ASSEMBLY (w/ engine under cover assembly)
10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT:
Front Wheel Alignment

11. CHECK ABS SPEED SENSOR SIGNAL
HINT:
Test Mode Procedure