Installation

U151E AUTOMATIC TRANSAXLE: DIFFERENTIAL OIL SEAL: INSTALLATION

INSTALLATION

1. INSTALL TRANSAXLE HOUSING OIL SEAL





(a) Coat the lip of the oil seal with MP grease.
(b) Using SST and a hammer, install a new oil seal.
SST: 09316-60011
09316-00011
Oil seal installation depth:
-0.5 to 0.5 mm (-0.020 to 0.020 in.)
2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH Installation
3. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL





(a) Coat the lip of the oil seal with MP grease.
(b) Using SST and a hammer, install a new oil seal.
SST: 09223-15020
SST: 09950-70010
09951-07150
Oil seal installation depth:
-0.5 to 0.5 mm (-0.020 to 0.020 in.)
4. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH Installation
5. INSTALL FRONT AXLE ASSEMBLY LH Installation
6. INSTALL FRONT NO. 1 SUSPENSION ARM SUB-ASSEMBLY LOWER LH Installation
7. INSTALL TIE ROD END SUB-ASSEMBLY LH Installation
8. INSTALL SPEED SENSOR FRONT LH Installation
9. INSTALL FRONT STABILIZER LINK ASSEMBLY LH Installation
10. INSTALL FRONT AXLE SHAFT LH NUT Installation
11. INSTALL FRONT WHEELS
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)
12. ADD AUTOMATIC TRANSAXLE FLUID
13. INSPECT AUTOMATIC TRANSAXLE FLUID U151F Automatic Transaxle
14. INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 engine under cover)
15. INSTALL NO. 1 ENGINE UNDER COVER
16. INSTALL ENGINE UNDER COVER ASSEMBLY (w/ engine under cover assembly)
17. CHECK ABS SPEED SENSOR SIGNAL Installation
18. PERFORM INITIALIZATION
HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.