Power Source Circuit
WIPER AND WASHER: WIPER AND WASHER SYSTEM: Power Source Circuit
Power Source Circuit
DESCRIPTION
This circuit provides power to the combination switch.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK WIRE HARNESS (SWITCH - BATTERY AND BODY GROUND)
(a) Disconnect the C11 switch connector.
(b) Measure the voltage of the wire harness side connector.
Standard voltage:
(c) Measure the resistance of the wire harness side connector.
Standard resistance:
NG -- REPAIR OR REPLACE HARNESS AND CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE