B156B

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: B156B,B156E: Multi-media Interface ECU Disconnected
B156B - Multi-media Interface ECU Disconnected
B156E - No Response from Multi-media Interface ECU

DESCRIPTION

The display and navigation module display and the multi-media interface ECU are connected by the AVC-LAN communication line.

When an AVC-LAN communication error occurs between the display and navigation module display and the multi-media interface ECU, these DTCs are stored.

HINT
* *: Even if no fault is present, this DTC may be stored depending on the battery condition or engine start voltage.
* The display and navigation module display is the master unit.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)

(a) Check for optional components.

(1) Check that optional components (including associated wiring) which generate radio waves are not installed.

Result

HINT
* Electrical noise from radio waves generated by optional components or the wiring for those components may affect AVC-LAN communication.
* This DTC may be stored when an AVC-LAN communication error occurs due to electrical noise.
B -- CHECK FOR DTC
A -- Continue to next step.

2. REMOVE OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)

(a) Remove the optional components (including associated wiring).

NOTICE:
Do not remove the optional components or associated wiring without the permission of the customer.

NEXT -- Continue to next step.

3. CHECK FOR DTC

(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(b) Check for DTCs and check if the same trouble occurs again.

OK:

No DTCs are output.

NG -- CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU POWER SOURCE)

OK -- END

4. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU POWER SOURCE)

(a) Disconnect the H15 multi-media interface ECU connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Text in Illustration

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA INTERFACE ECU - DISPLAY AND NAVIGATION MODULE DISPLAY)

(a) Disconnect the H15 multi-media interface ECU connector.

(b) Disconnect the H14 display and navigation module display connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. REPLACE MULTI-MEDIA INTERFACE ECU

(a) Replace the multi-media interface ECU Removal.

(b) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(c) Check for DTCs and check if the same trouble occurs again.

OK:

No DTCs are output.

NG -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY Removal

OK -- END