Installation

1UR-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH: INSTALLATION

1. INSTALL POWER STEERING OIL PRESSURE SWITCH

(a) Install a new O-ring to the power steering oil pressure switch.

(b) Apply a light coat of engine oil to the O-ring.

(c) Using SST, install the power steering oil pressure switch.

SST : 09922-10010

without SST - Torque : 21 Nm (210 kgf-cm, 15 ft-lbf)

with SST - Torque : 15 Nm (148 kgf-cm, 11 ft-lbf)

Text in Illustration





HINT
* Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Service Precautions.
* Make sure SST and the torque wrench are connected in a straight line.





(d) Connect the power steering oil pressure switch connector.

2. INSTALL FAN AND GENERATOR V BELT

(a) Install the fan and generator V belt Installation.

3. ADD POWER STEERING FLUID

4. BLEED AIR FROM POWER STEERING SYSTEM Initial Inspection and Diagnostic Overview

5. INSPECT FOR POWER STEERING FLUID LEAK

6. CHECK POWER STEERING FLUID LEVEL Initial Inspection and Diagnostic Overview

7. INSTALL FRONT FENDER APRON SEAL RH Installation

8. INSTALL FRONT WHEEL Installation