Reassembly

A760H AUTOMATIC TRANSMISSION: OIL PUMP: REASSEMBLY

1. INSTALL FRONT OIL PUMP OIL SEAL

(a) Using SST and a hammer, install a new oil seal.





SST : 09350-30020

09351-32140

HINT
The oil seal end should be flush with the outer edge of the pump body.

(b) Coat the oil seal lip with MP grease.

2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY

(a) Place the oil pump body on the torque converter clutch.

3. INSTALL FRONT OIL PUMP DRIVEN GEAR

(a) Coat the driven gear with ATF.





(b) Install the driven gear to the oil pump body.

4. INSTALL FRONT OIL PUMP DRIVE GEAR

(a) Coat the drive gear with ATF.





(b) Install the drive gear to the oil pump body.

5. INSTALL FRONT OIL PUMP BODY O-RING

(a) Install a new O-ring to the oil pump body.





6. INSTALL STATOR SHAFT ASSEMBLY

(a) Align the stator shaft with each bolt hole.





(b) Install the 14 bolts.

Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)

7. INSTALL CLUTCH DRUM OIL SEAL RING

(a) Coat 3 new oil seal rings with ATF.





(b) Squeeze the ends of the 3 oil seal rings so that the gap distance becomes 8 mm or less, and then install them to the starter shaft groove.

NOTICE:
Do not expand the ring ends excessively.

HINT
After installing the oil seal rings, check that they rotate smoothly.

8. INSPECT OIL PUMP DRIVE GEAR ROTATION Oil Pump

9. INSTALL FRONT OIL PUMP BODY O-RING

(a) Install a new O-ring to the oil pump assembly.