B2413

LIGHTING: LIGHTING SYSTEM: B2412,B2413: Headlight Swivel Motor LH Malfunction
B2413 - Headlight Swivel Motor RH Malfunction

DESCRIPTION

The swivel actuator receives a signal from the AFS ECU to operate and sends a signal regarding the direction of the headlight and condition of the headlight swivel motor to the AFS ECU.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / AFS / Active Test.

(e) Check the operation.

AFS (AFS ECU)

AFS (AFS ECU):

OK:

Swivel motor operates.

Result:

C -- INSPECT HEADLIGHT ASSEMBLY

B -- REPLACE AFS ECU

A -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

2. INSPECT HEADLIGHT ASSEMBLY

(a) Disconnect the B12 and B2 headlight assembly connectors.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

LH Side (B2412)
RH Side (B2413)

HINT
Measure the resistance after the headlight has cooled.

NG -- REPLACE HEADLIGHT ASSEMBLY
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (HEADLIGHT ASSEMBLY - AFS ECU)

(a) Disconnect the A28 AFS ECU connector.

(b) Disconnect the B12 and B2 headlight connectors.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

LH Side (B2412)
RH Side (B2413)

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. CHECK AFS ECU

(a) Disconnect the B12 and B2 headlight connectors.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

LH Side (B2412)
RH Side (B2413)

NG -- REPLACE AFS ECU
OK -- Continue to next step.

5. REPLACE HEADLIGHT ASSEMBLY

(a) Temporarily replace the headlight assembly with a new or normally functioning one.

(b) Check that the headlight assembly operates.

OK:

Returns to normal operation.

NG -- REPLACE AFS ECU

OK -- END