Installation

SEAT BELT: OCCUPANT DETECTION SENSOR (for Power Seat): INSTALLATION

1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD

(a) Using hog ring pliers, install the separate type front seat cushion cover to the seat cushion pad with new hog rings.





NOTICE:
* Be careful not to damage the cover.
* When installing the hog rings, take care to minimize wrinkles as much as possible.
2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

(a) Connect the hooks to install the separate type front seat cushion cover with pad.





(b) Install the 2 clips.

(c) Engage the clamp to install the occupant detection sensor connector.





(d) Connect the connectors and clamps.





3. INSTALL FRONT POWER SEAT SWITCH (w/ Seat Position Memory System)

(a) Connect the 2 connectors.





(b) Install the front power seat switch with the 3 screws.

4. REMOVE FRONT POWER SEAT SWITCH (w/o Seat Position Memory System)

(a) Connect the connector.

(b) Install the front power seat switch with the 3 screws.

5. INSTALL FRONT SEAT INNER CUSHION SHIELD RH Installation

6. INSTALL FRONT SEAT CUSHION SHIELD WITH NO. 1 CUSHION SHIELD INNER

(a) Connect the connector to the lumbar front power seat switch.





(b) Engage the claw to install the cushion shield with No. 1 cushion shield inner.

(c) Install the 6 screws.

(d) Install the 2 rubber bands of the front seatback board to the seat frame.





(e) Connect the connector to the No. 1 interior illumination light.

7. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

8. INSTALL RECLINING POWER SEAT SWITCH KNOB

9. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH

(a) Install the 4 clamps.





(b) Connect the connector.

(c) Install the front seat inner belt assembly RH with the nut.





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTICE:
Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding parts of the front seat adjuster.

10. INSTALL FRONT SEAT ASSEMBLY RH

(a) Place the seat in the cabin.





(b) Connect the connectors under the seat.

(c) Connect the cable to the negative (-) battery terminal.

(d) Operate the power seat switch knob and move the seat to the position farthest forward.

(e) Temporarily install the 2 bolts on the rear seat track bracket.

(f) Operate the power seat switch knob and move the seat to the rearmost position.

(g) Temporarily install the 2 bolts on the front seat track bracket.

(h) Tighten the 4 bolts in the order indicated in the illustration.

Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

11. INSTALL REAR OUTER SEAT TRACK COVER RH

(a) Operate the power seat switch knob and move the seat to the position farthest forward.

(b) Engage the 2 claws to install the rear outer seat track cover RH.





12. INSTALL REAR INNER SEAT TRACK COVER RH

13. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER RH

(a) Operate the power seat switch knob and move the seat to the rearmost position.

(b) Engage the 2 claws to install the front outer seat track bracket cover RH.





14. INSTALL FRONT INNER SEAT TRACK BRACKET COVER RH

15. INSTALL FRONT SEAT HEADREST ASSEMBLY

16. INSPECT SRS WARNING LIGHT

Inspect the SRS warning light. Diagnosis System

17. INSPECT FRONT SEAT ASSEMBLY

Installation